Highly Effective for both, Machine & Hand Soldered PCBs
Leaves No Sticky Patches and Streaks on the PCBs
Improves performance & reliability of the assembly
Economical, can be used repeatedly for many PCBs
Safe for almost all components
Colour codes and prints on the components remain intact
Removes oxidation from component leads, PCBs
Saves lot of time
Easy to use
Safe for plastics and paints
No multiple baths to be maintained
Long shelf life
Low evaporation losses
Needs light brushing with a brush of your choice
Available in 1 ltr Trial Pack & 5 ltr Economy Pack
Take a plastic (poly propylene) container having a tight lid
Pour adequate quantity of xyloclin in the container to cover the boards
Dip the boards in xyloclin. Cover the container properly with the lid
Soak the boards for about twenty minutes
Brush the boards from both sides using a hard PCB cleaning brush
Wash the boards with little brushing under running water thoroughly
Soak the boards in a fresh water for five minutes
Remove the boards from water bath & dry the boards before use
Store xyloclin in a container with a tight lid for future use. xyloclin can be reused several times. More the flux, lesser the life of xyloclin
Replace used xyloclin with a fresh xyloclin if you don't get the desired results
If you feel that any particular, delicate component may not withstand dipping in xyloclin, test the component independently with xyloclin else remove the component before cleaning